Back to Blog
Mini vmac autolaunch7/1/2023 Of course, if you only use a USB sound card, the following settings are not required.įirst, install the USB sound card and check if it is recognized. For example, when HDMI is connected, the onboard chip of Raspberry Pi has priority, and there is a symptom that it is not output from the USB sound card. The cause is when there is audio output other than the USB sound card. If there is no sound after installing the WAVESHARE USB sound card, you need to set it. Once these are ready, the Mini vMac will be ready for acceptance. * The reason is that my approach may not be good, but I tried rc.local, Systemd, and cron, but it didn't work, and in conclusion, I wrote it in ".bashrc". Install the minimum Xwindow related required to boot a Mini vMac over the CLI.Įnable "Console Autologin" in the familiar "raspi-config". (Personal opinion)Īfter inserting the Micro SD card into the Raspberry Pi and booting, let's upgrade the OS first. Since various settings are troublesome with CLI, to shortcut the work. * At that time, set the network and SSH with "Ctrl + Shit + X". Use Raspberry Pi Imager for installation. The settings do not need to be done on a small screen. * The GPIO display will be installed and set at the end. Also, prepare an appropriate amount of decals according to your preference.When shaping and painting, please prepare the necessary tools.Glue gun or glue or Epoxy putty (for fixing external access cables or USB hubs).Screw M3 12mm: 1pcs (Choose flat head screws as much as possible).Micro USB cable for USB hub 10cm : 1pcs.Micro USB cable for power extension 10cm: 1pcs.Micro SD card reader extension adapter 15cm: 1pcs.
0 Comments
Read More
Leave a Reply. |